7
Ground Cable
Auto Turn On
Power Cable
• At least eight gauge cable should be used for the ground connection to the
amplifier.
• The amplifier ground should be connected directly to the chassis of the
vehicle, to bare metal.
• The cable length should be kept to an absolute minimum.
• It is not recommended that you connect the ground cable to the vehicles
seat belt anchor point.
• The CVENC8-V4 features an auto turn on circuit.
• This circuit allows the amplifier to switch on and off without a remote turn on
wire when using high level input.
• When the connected source (headunit) is turned on the amplifier will turn on
automatically, after the connected source (headunit) is turned off the amplifier
will shut down after one minute.
• If using low level input (RCA) it will still be necessary to connect the remote
turn on wire.
• At least eight gauge cable should be used for the power connection to the
amplifier.
• The power cable should be taken directly from the battery. Rubber
grommets should be used when passing through any bulkheads to prevent
the cable from becoming chaffed or cut.
• It is vital that a fuse / circuit breaker of 25 amps is placed in-line with the
power cable and is no further than eighteen inches away from the battery.
• Please ensure that the fuse is not fitted until the entire installation procedure
is complete.
