Viavi Xgig, User Manual

Page: 235 / 468

Working With Domains Chapter 12, Getting Started with Xgig TraceView
Xgig Analyzer User’s Guide 221
The right panel displays an icon for each port, arranged as they physically exist within the Xgig
chassis. To select a port, click the port. Single ports can be selected within TraceView. Click the
background area of a port-pair to select both ports in the pair. Click ports again to remove them
from the selection. Selected ports have a blue background, unselected ports have a white
background.
TraceView allows the selection of ports that contain valid capture data only. If no ports contain
valid capture data, no port can be selected. The icons change as the selection, availability, and type
of each port changes. See
“Selecting Chassis, Blades, Ports, and Segments” on page 221 for
information on the display of port icons.
Dialog Buttons
If you are not logged into the Sync Group that contains the resources in the domain, use the
Password
field to login. Login is only required if the Sync Group is password protected.
The following buttons are available:
•
Blink
Causes the LEDs for the selected ports to blink. LEDs will blink for 40 seconds.
•
Stop
Causes the LEDs to stop blinking.
•
OK
Exit and use the selected chassis and ports in TraceView.
•
Cancel
Close the window; no domains or ports will be used.
•
Refresh
Updates the status of blades and ports in the right panel and available Sync Groups in the left
panel.
Selecting Chassis, Blades, Ports, and Segments
The dialog box displays an icon for each port, arranged as they physically exist within the analyzer
hardware device(s). The icons change as the selection, availability, and type of each port changes.
Ports show individually but have the same status for each port in a port-pair. In TraceView, you
can select individual ports for display. You can view the trace of up to 64 ports at the same time
from TraceView. Note that a “tool tip” displays showing information about the port when you pass
the cursor over any port.