INSTALLATION DATA
Model 509
Wiring:
Model 709
Wiring:
Model 809
Wiring:
Pin A:
Pin B:
Pin C:
Pin D:
Pin E:
+Signal
- Signal
No Connection
No Connection
+Calibration
Pin A:
Pin B:
Pin C:
Pin D:
Pin E:
Pin F:
+Power
- Power
+Signal
- Signal
Calibration
Calibration
Pin A:
Pin B:
Pin C:
Pin D:
Pin E:
Pin F:
+Power
-Power
+Signal
-Signal
Calibration
Calibration
ADAPTER
ASSEMBLY
Pin F: - Calibration
Grn Ter: Case Ground
SENSOR
ASSEMBLY
O-RING
Grn Ter: Case Ground
Grn Ter: Case Ground
To activate cal on Model 509, the cal circuit must be powered.
To activate cal on Models 709 & 809 short pins E & F.
Input:
9-30VDC
10.5-28 VDC
Input:
9-30VDC
10.5-28 VDC
Input:
10-15VDC
input for approved units
Fig.2
Adapter & Connector Bolt Torque Settings*
Connector Fasteners:
Size 4-40 (with gasket) = 4 in-lbs
Size 4-40 (no gasket) = 8 in-lbs
Size 6-32 = 25 in-lbs
Adapter Fasteners:
Size 8-32 = 40 in-lbs
Output:
4 to 20mA
Output:
0 to 5VDC
Output:
3.0mV/V
Sensor Construction:
All Ranges: Inconel X-750
Electrical Connector:
6 pin bayonet (standard)
*
Lightly hand-tighten bolts in alternating fashion (star pattern). Ensure that the item to be secured is fully and evenly
seated, and the O-ring, if applicable, is fully compressed. Torque bolts in alternating fashion (star pattern).
Pressure Connection By Range:
5,000, 10,000, 15,000 & 20,000 PSI: 1502 Hammer Union
Connection Diagrams
(Non Hazardous environments)
For Hazardous locations, see attached connection
Diagram per approval code ordered.
STANDARD VIATRAN PRODUCT MARKING
MODEL 509
MODEL 709 & 809
3
98MANALX09 Rev, K
VOLT
