Activating Remote
Pull the strip from the battery compartment on the back of the remote. To test
the remote’s battery connection, press any button and the LED will illuminate
for 1 second. If the LED does not illuminate, open the battery compartment to
make sure battery is properly installed.
Assembly
Screw the ground stake or mounting plate into the bottom of the light projector
clockwise until tight (fig. 1). To adjust the angle of the light projector, loosen the
pivot clamp screw by turning it counterclockwise. Once the angle adjustment
is made, twist the pivot clamp screw clockwise until tight to secure (fig. 2).
Plug the 2-prong adapter into the power supply transformer. Screw on the
weather-resistant cap tightly to help protect the connection from weather.
The mounting plate can be attached to a wooden structure such as a deck
using 4 screws (not included). The unit
can be detached from the mounting plate
without removing the entire assembly simply
by unscrewing the unit counterclockwise.
IMPORTANT:
Point Night Stars directly at your home and never point
Night Stars directly into the sky. Do not project Night Stars at or within
the flight path of an aircraft within 10 nautical miles of an airport. If the
surface at which you intend to point the Night Stars laser is within 10
nautical miles of an airport, lower the angle so that it does not point into
the sky.
Do not point laser light toward oncoming pedestrians, vehicles, or
traffic routes on land, sea, or air.
Operation
Press the button on the back of the laser unit to set shimmer speed or
turn off. Settings are fast, medium, slow, still, and off. Pressing this button clears flash settings. See the
below chart for remote operations. The remote can be used hand-held or mounted to a surface.
COLOR
FLASH
2H
8H
6H
4H
RESET
Shimmer Speed
4 settings: still, slow, medium, fast
Change Light Color
Choose red, green, or dual-colored light
(Clears flash setting)
Reset
Cancels timer settings
6-Hour Timer
Sets the unit on a 6-hour on,
18-hour off daily cycle
8-Hour Timer
Sets the unit on an 8-hour on,
16-hour off daily cycle
2-Hour Timer
Sets the unit on a 2-hour on,
22-hour off daily cycle
4-Hour Timer
Sets the unit on a 4-hour on,
20-hour off daily cycle
Light On/Off
Press On/Off while unit is plugged in and
remote will connect to unit in 5 seconds
Flash Setting
Toggle between flashing
or steady light
IF REMOTE IS NOT CONTROLLING THE LASER
while you are within remote control
range, and if the remote LED comes on when you press the buttons, your remote may not be synced
with the laser light. In this case, follow these syncing instructions:
Syncing the Remote:
Be sure you are within 5 ft. of laser to sync. Do not use an extension cord during syncing process.
1. Remove the battery from the remote, then reinstall battery. This resets the remote.
2. Unplug the laser from the power source and wait 1 minute. This resets the laser.
3. With remote in hand, plug laser into wall outlet. QUICKLY, BEFORE 3 SECONDS PASS, press
the ON/OFF button on remote AFTER plugging the laser in. DO NOT press the ON/OFF button at
the same time you plug in, it must be done within 3 seconds AFTER plugging in. DO NOT hold the
button down.
Do not use an extension cord during syncing process. Once the laser is synced, it may be unplugged
and used with an extension cord. Occasionally, re-syncing the remote with the laser may be necessary.
In this case, repeat the steps above. To sync two or more lights to the same remote, unplug them all,
then plug them back in at the same time. AFTER plugging them in, press the ON/OFF button within 3
seconds. Remove remote battery before long-term storage.
Range: Up to 11 yards
Fig. 1
Fig. 2
