ViAS VENGE, Instruction Manual

Page: 24 / 36

21
C. CONNECTING HANDLEBAR TO STEM (
mechanical)
1
A
A
B
2
C
Sheath
Housing
„ Fig.1: Assemble the shift and brake parts of the cable guide assembly
A
(S164800003),
using a M3 x 0.5mm x 8mm countersunk Allen bolt
B
and 2mm Allen key.
„
Fig.2: Unscrew the shift guide set screws
C
, then insert a shift cable into its guide hole. Pull
the cable through the guide until the sheath and housing are fully seated in the guide.
„
Once seated, tighten the set screw until it bottoms out. This will engage the set screw threads
into the rubber outer sheath of the shift housing, securing the housing in place. The sheath will
now be trapped in place between the shift housing and the shift guide body. Repeat this step for
the 2nd shift cable and housing.
„ Fig.2: Insert each brake cable and housing into the cable guide assembly until fully seated.
3
„
Fig.3: Run the cables into the stem body, then guide the cables through their respective
channels (stem shim channels - Fig.6, page 22 ), until the shift cables exit the bottom of
the stem and the brake cables exit the top of the stem.
„
Gradually guide the stem over the cable guide assembly and the cable housings. As the guide
assembly and housings enter the stem body, pull the cables out the back of the stem until the
handlebar is placed against the stem body.
4
D
„
Fig.4: Place the ReachR tool (or a long 3mm Allen key) below the handlebar slot and into the
head of the cable guide assembly bolt
D
.
„ Bolt the guide assembly to the stem body. Using the ReachR tool and torque wrench, tighten
the bolt to 45 in-lbf (5.1 Nm).
The ReachR tool is a custom tool designed to help install the cable guide
assembly inside the stem (kit includes PointR tool).
ReachR Tool:
S165300010