The 845D-MVT MAINBOARD
Page 12
*! "#!
Hardware Installation
Speaker and Power LED Connectors
PWR-LED
SPK
Power LED
Speaker Connector
Jumpers and Switches
JP1
JP3
JP4
KB/MS Power On
Clear CMOS
Clear Password
Note: Before you start installing your mainboard we strongly recommend that you
use a grounded anti-static mat. We further recommend that you attach an anti-static
wristband, which is grounded at the same location as the mat to your wrist.
You need to complete the following installation steps before you use your PC.
!
Check and set the mainboard settings.
!
Install the Central Processing Unit (CPU).
!
Install the memory modules.
!
Install the expansion cards.
!
Connect the ribbon cables, panel wires and power supply.
!
Setup the system BIOS
2.4.1. Installation of the CPU
To install your processor, please complete the following set of instructions
1. Locate a small dot marked on the top of the CPU. This mark indicates
Pin 1 of the CPU.
2. Locate Pin 1 for the Socket on the mainboard.
3.
There is a lever on the side of the socket. First push this lever side-
ways and then lift it to a 90-degree angle.
4.
Insert the CPU into the Socket. Please make sure that Pin 1 for the
CPU is inserted into Pin 1 of the Socket.
5. When the CPU is installed correctly push the lever back into place.
6. Install a proper heat sink with cooling fan for proper heat dissi-
pation. Failing to install a heat sink with cooling fan may cause over-
heating which will burnout your CPU and damage your mainboard.
IMPORTANT: CPU COOLING FAN
Please ensure that you have an approved heat sink with cooling fan. Without a proper
heat sink with cooling fan you will damage both the mainboard and the CPU.
%/0& #! " !
