5. Overdrive Level: Adjusts the volume level of Overdrive Channel.
6. Bass: Adjusts the low frequency level. Turn this knob clockwise to boost the bass sound, counter clockwise to cut the bass sound accordingly.
Center position (straight up) provides no cut or boost.
7. Mid: Adjusts the middle frequency level. Turn this knob clockwise to boost the middle sound, counter clockwise to cut the middle sound
accordingly. Center position (straight up) provides no cut or boost.
8. Treble: Adjusts the high frequency level. Turn this knob clockwise to boost the treble sound, counter clockwise to cut the treble sound
accordingly. Center position (straight up) provides no cut or boost.
9. Reverb: Adjusts the amount of sound reverberation/reflection effect to the guitar’s signal.
10. Master Volume: Overall volume adjustment for both channels. Turn this knob clockwise increases the overall sound level.
11. Power Indicator: LED will be lit when the amplifier power is on.
12 . Standby Switch: When this Switch is in the upward position (On), this mode keeps tubes powered-up and avoids delay times (Time it
takes for tubes to warm up) for guitar players between practice sessions. It also lengthens tube lifetime performance.
13. Power Switch: Use this switch to turn the amplifier on or off. *
* The power/mains switch is a one pole switch. The apparatus is not completely disconnected from the power/mains when turning the switch “off”. The power/
mains plug or appliance coupler is the disconnect device which must remain readily operable.
B. THE REAR PANEL
Fig. 2: The Rear Panel
14. Power IEC Socket: Use the included power cord with this unit in accordance with the voltage and frequency ratings listed on this
manual and rear panel of this amplifier.
15. HT Fuse: The fuse is the amplifier’s protection device. In the event of an over power malfunction, the fuse will blow, disconnecting the power
source and the amplifier, therefore preventing the amplifier from severe damage. If the amplifier shuts down while in use, unplug the amplifier,
open the fuse holder, check the fuse and replace if necessary (Replaced fuse must be at the same rating voltages and current). Consult a
qualified service technician if problem continues.
16. Footswitch: Controls Clean/Overdrive Channel Select and Reverb On/Off with dual footswitch.
HT FUSE
T1AL250V
100V~
120V~60Hz
230V~50Hz
240V~50Hz
T2AH250V
T2AH250V
T1.6AH250V
T1.6AH250V
Input Power
100W
Voltage
Fuse Rating
5060Hz
Laite on littettava suojamaadoituskoskettimilla
va rustettuunpistorasiaan
Apparatet ma tilkoples jordet stikkontkakt
Apparaten skall anslutas till jordat uttag
-- --
RISK OF ELECTRIC SHOCK, DO NOT OPEN!
CHASSIS SURFACE HOT!
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR
MOISTURE. INDOOR USE ONLY!
AVIS: RISQUE DE CHOC ELECTRIQUE NE PAS OUVRIR
ATTENTION: SUPERFICIE DE CHASSIS CHAUDE
CAUTION
SERIAL NUMBER
FOOTSWITCH
FX SEND
FX RETURN
SERIAL/PARALLEL
FX
SPEAKER OUTPUTS
16 ohms
8 ohms
15
16
14
17 18 19
20
21
6
7
