Vetus-Maxwell RC12-HD, Manual

Page: 14 / 31

12 www.maxwellmarine.com
4.2 PRESSURE ARM REPLACEMENT
1. Using a 5mm hex key undo the capscrew on chaincover. Be careful when releasing
the capscrew as the pressure arm spring may spring out.
2. Remove the spring and pressure arm
3. Apply liberal amounts of grease to the spring and insert it into the pressure arm
4. Ensure the lower spring pin sits in the groove of the pressure arm as shown.
5. With the spring in the pressure arm,align the spring pin into the groove located inside
of the chaincover, and slide the pressure arm in.
6. Looking from above align the pressure arm with the hole for the capscrew.
7. While holding the pressure arm in this position.
8. Assemble the capscrew.