Vetter SmartFork SmartSupply SF-SUPPLY-V10-00X, Operating Instructions Manual

Page: 21 / 28

4.2 Replacement of the SmartSupply
Personnel: n Service specialist
Protective equipment: n Industrial safety helmet
n Protective clothing
n Protective gloves
n Safety shoes
New pairing necessary after replacement!
The SmartSupply needs to be “paired” with the broker following replace-
ment of a client Ä Chapter 3.2 “Pairing ” on page 18.
The SmartSupply needs to be “paired” with the client and the SmartDis-
play if a broker is replaced Ä Further information on page 18.
1. Remove the battery from the Smart Supply (Fig. 7).
Fig. 8: Screw connection of the SmartSupply
2. Loosen and remove the three countersunk screws on the outside of the connection
panel (Fig. 8)
Disassembly,
SmartSupply
variant BAT
Maintenance
Replacement of the SmartSupply
EN
SmartFork
®
SmartSupply
21