INSTALLATION TESTS
Once installation is complete, the computer should be tested to
make sure it is working properly.
If there is no speed reading, make sure the timers (RT/TT) are
running, check the alignment and spacing between the magnet
and sensor/transmitter and make sure that the head unit is
completely snapped into position. If these checks do not solve
the problem, talk to an Authorized Vetta Retailer or connect to
www.vetta.com.
IMPORTANT:
Following the installation tests above, make
sure that the spoke magnet locking screw and all zip ties are
properly tightened.
Tips:
Rotating the angle of the transmitters or the handlebar
receiver (slightly), can sometimes improve the signals being sent
and received. Some bicycles have unusual frame tubes and
angles, so by adjusting the components, can aid in trouble
shooting by aligning the misdirected signals.
Step 1:
Step 2:
Advance the computer to the SPD/DST screen mode
using Button #2.
Pick up the front of the bicycle and spin the front wheel.
The computer should display a speed reading within 2-3
seconds.
PROBLEM/ITEMS TO CHECK/SOLUTION
TROUBLESHOOTING
•
Current speed reading is erratic or does not appear.
Check the alignment of the spoke magnet and sensor, and the
distance between the two components. Realign the magnet
and sensor with the spacer. Check to be sure RT and TT are
activated.
