2
VETRA
Systems Corporation 275 Marcus Blvd. Ste-J, Hauppauge, NY 11788-2022 USA
Phone: 631.434.3185 Fax: 631.434.3516
e-mail: [email protected] http://www.vetra.com
Or in the case of the V2 and V3 series MegaSwitch
Connect PC#1’s Monitor A video output to the backpanel connector of the Switch marked “PC1 MON A” and connect PC#1’s
Monitor B video output to the backpanel connector of the Switch marked “PC1 MON B” and PC#1’s Monitor C video output to
the backpanel connector marked “PC1 MON C”. Repeat this step for PC#2.
Serial Touch Screen (Touch Screen models only)
Connect the Serial Touch Screen inputs of the PC’s to the Switch using 9 pin DB9 male/female extension cables. Connect
PC#1’s serial touch screen input to the backpanel connector of the Switch marked “TO PC1 T.S.”. Connect PC#2’s serial
touch screen input to the backpanel connector of the Switch marked “TO PC2 T.S.”.
Audio (Audio models only)
Connect the Microphone inputs of the PC’s to the Switch using a stereo cable male/male with 3.5 mm plugs at connectors
marked “TO PC 1 MIC “ and “TO PC 2 MIC”. Connect the speaker outputs of the PC’s to the Switch also using a stereo cable
male/male with 3.5 mm plugs at connectors marked “TO PC 1 SPKR” and “TO PC 2 SPKR”.
2. Connect a Workstation to the Switch:
a) PS/2 Keyboard
Connect the keyboard to the 6-pin DIN connector on the front panel of the Switch marked "PS/2 KBD
IN".
b) PS/2 Mouse
Connect the mouse to the 6-pin DIN connector on the front panel of the Switch marked "PS/2 MSE IN".
c) VGA Monitor(s)
Connect the VGA monitor to the 15-pin HDD connector on the backpanel of the Switch marked "MON
IN".
Or in the case of the V2 and V3 series MegaSwitch
Connect the VGA Monitor A to the 15-pin HDD connector on the back panel of the Switch marked “MON A IN”. Repeat for
Monitors B and C.
d) Serial Touch Screen models only
Connect the Touch Screen to the 9-pin DB9 connector on the backpanel of the Switch
marked “TOUCH SCREEN IN”.
e) Audio models only
Connect the microphone to the connector on the Switch marked “AUDIO INPUTS MIC IN” and
connect to the speakers to the connector marked “AUDIO INPUTS SPKR IN”.
3. Connect the Power Supply to the MegaSwitch:
The MegaSwitch is powered by an external wall plug-in supply the VIP-210 (+5Vdc 1A reg. 100 – 120 Vac 50 – 60 Hz). First
plug the power output plug of this external supply into the mating jack on the backpanel of the MegaSwitch marked “5VDC
IN”, and only then plus the supply into a suitable AC power source. Since the MegaSwitch has no separate power on/off
switch, it is recommended that the power supply be connected to an AC power source that has a power on/off switch.
OPERATION
1. Power Up Sequence:
There is no separate power control for the switch. The switch derives its power directly from the external power
supply supplied with the MegaSwitch. The MegaSwitch MUST be powered up first before any of the PC’s are
power up to ensure proper communications from the MegaSwitch to the PC’s. Any other power up sequence will
not guarantee the integrity of the communications between the PC’s and MegaSwitch.
