User Instructions for
VIP- 602 USB-PS/2 Series "MegaSwitch"
Keyboard, Mouse, Audio, and Video Switch
FEDERAL COMMUNICATIONS COMMISSION
This equipment has been tested and found to comply with the limits of a Class A digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference when equipment is operated in
a commercial environment. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and
used in accordance with the instruction manual, may cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at their expense.
CE
This equipment has been tested and found to conform to the directives and standards for a Class A Information Technology
Equipment type and for the Commercial Light Industrial equipment class.
INTRODUCTION
The VIP-602 USB-PS/2 "MegaSwitch"
Keyboard, Mouse, Audio, and Video Switches are available as a full function,
Integrated Switch with keyboard control selection, switching keyboard, mouse, and video. Models are also available for
switching Audio, Serial Touch Screen, and Dual Video. The "MegaSwitch" allows one Workstation comprised of a PS/2
Keyboard, a PS/2 Mouse, and VGA Monitor(s) to control and work with one or two PS/2 or USB PC's. All models come with
the VIP-210 power supply.
Note: The "MegaSwitch does not come with PS/2, USB, Audio, Serial, or VGA extension cables.
They may be
ordered from Vetra separately.
INSTALLATION
There are three main steps to connect the Switch:
1. Connect PC's to Switch unit:
PS/2 PC’s
a) PS/2 Keyboard Port
Connect the keyboard inputs of the PC's to the Switch using 6 pin PS/2 male/male extension
cables. Connect PC#1's keyboard port to the backpanel connector of the Switch marked "TO PC1 K". Connect
PC#2's keyboard port to the backpanel connector of the Switch marked "TO PC2 K".
b) PS/2 Mouse Port
Connect the mouse inputs of the PC's to the Switch using 6 pin PS/2 male/male extension
cables. Connect PC#1's mouse port to the backpanel connector of the Switch marked "TO PC1 M". Connect PC#2's
mouse port to the backpanel connector of the Switch marked "TO PC2 M".
USB PC’s
Connect the USB ports of the PC’s to the Switch using a Mini USB 4-pin type A male to type B male cable. Connect PC#1’s
USB port to the backpanel connector of the Switch marked “TO PC1 USB PORT”. Connect PC#2’s USB port to the
backpanel connector of the Switch marked “TO PC2 USB PORT”.
Video
Connect the Video outputs of the PC's to the Switch using 15 pin HDD15 male/female extension cables. Connect PC#1's
video output to the backpanel connector of the Switch marked "PC1 MON". Connect PC#2's video output to the backpanel
connector of the Switch marked "PC2 MON".
275 Marcus Blvd Ste-J Hauppauge, NY 11788-2022 USA
Tel: 631.434.3185 Fax: 631.434.3516
www.vetra.com email:[email protected]
