2
VETRA
Systems Corporation 275 Marcus Blvd. Ste-J, Hauppauge, NY 11788-2022 USA
Phone: 631. 434.3185 Fax: 631. 434.3516
e-mail: [email protected] http://www.vetra.com
2. Connect a Monitor to Switch unit:
a)
Connect the VGA monitor to the 15-pin HDD connector on the backpanel of the Video Switch marked "MONITOR
IN".
Or in the case of V2 series
Connect VGA monitor A to the backpanel connector on the Video switch marked “MONITOR A IN” and VGA
monitor B to the connector marked “MONITOR B IN”.
b)
Connect the Touch Screen to the 9-pin DB9 connector on the backpanel of the Switch marked “TOUCH SCREEN
IN”.
Or in the case of V2 series
Connect Touch Screen A to the backpanel connector on the Video switch marked “TOUCHSCREEN A IN” and
Touch Screen B to the connector marked “TOUCHSCREEN B IN”.
3. Connect the Power Supply to the Video Switch:
The Video Switch is powered by an external wall plug-in supply the VIP-210 (+5Vdc 1A reg. 110 – 240 Vac 50 – 60 Hz).
First plug the power output plug of this external supply into the mating jack on the backpanel of the Video Switch marked
“+5VDC IN”, and only then plug the supply into a suitable AC power source. Since the Video Switch has no separate power
on/off switch, it is recommended that the power supply be connected to an AC power source that has a power on/off switch.
OPERATION
1. Power Up Sequence:
The switch derives its power from an external power supply provided with the MegaTouch. When the Video Switch is
powered up, observe on the Video Switch that the front panel Led marked “PWR ON” comes on.
2. Monitor Selection:
a) Front Panel Selection:
1) NEXT MON (available on all Standard models):
To select another PC, press the “NEXT MON” pushbutton
located on the front panel of the MegaTouch. The MegaTouch will switch from on PC to the other. If PC #1 is
selected the MONITOR STATUS 1 SEL indicator will be on. If PC #2 is selected then the MONITOR STATUS 2
SEL for that PC will be on.
2) Direct Entry (available on DE models only):
To select another PC, press the MONITOR SELECTION
pushbutton for the appropriate PC desired.
b) Remote Control (available on all models):
The MegaTouch may also be switched via remote control. A Hex 31
for (PC #1) thru Hex 34 for (PC #4) sent via RS-232 to pin 2 of the DB 9 connector on the rear panel marked
“REMOTE CONTROL” will switch the MegaTouch from PC1 to PC2. The data format is one start bit, eight data
bits, least significant bit first, one stop bit and no parity. The baud rate is 9600. Pin 5 is ground.
