Rev.
12/20/2016
SST-45,
MANUAL.doc
Copyright 2015 Vestil Manufacturing Co.
Page 5 of 8
Step 4: Insert the bottom of the spring (each spring is
painted with a unique color near the bottom end as shown
on p. 2) into the spring receiver. Insert the base of the
spring between the frame and the spring-retaining tab.
Spring-retaining tab
Step 5: Compress the spring by pressing down on the
second or third loop (not the top of the spring) and
slide it under the tabletop.
Step 6: Make sure that the top of the spring
is properly seated inside the upper spring
receiver; then remove the clevis pin.
Spring
receiver
Spring properly
seated inside receiver
and plug reinstalled.
Step 7: Press the tabletop down until the latches catch; then pull
out the free end of the shock absorber and attach it to the shock
bracket using the clevis pin and linchpin.
Fasten shock to bracket:
Extend shock:
Bracket
Linchpin
Clevis
pin
Step 8: Reinstall the carousel (unit shown below
with all 3 springs installed).
Installing/Removing Springs:
Before loading the table, use the “Spring Combinations Table” on
p. 2 to determine if more than just the orange spring is required. If
the height and weight of a particular load requires adding springs,
determine which springs are necessary as well as their proper
placement as indicated in the “Spring combinations diagram” on p.
2. To install either the grey or purple spring:
1. Remove the appropriate
tabletop plug;
2. Insert the spring through
the opening. Make sure
that the spring is seated
properly;
3. Then, reinsert the plug and
turn it as far as possible
(the fins of the plug will
contact stops) to secure
the plug in place.
4. Look underneath the
tabletop to confirm that the
spring is properly seated
as shown in the
photograph to the right.
Spring seated inside upper
receiver with plug reinstalled.
