Rev. 6/12/2020
SHEET-R-57 MANUAL
Copyright 2020 Vestil Manufacturing Corp.
Page 2 of 5
SIGNAL WORDS
This manual uses SIGNAL WORDS to draw attention to uses of the product that could result
in personal injuries, as well as the probable seriousness of those injuries. Other signal words call
attention to uses likely to cause property damage. Signal words used in this manual appear below
along with their definitions.
Identifies a hazardous situation which, if not avoided, WILL result in
DEATH or SERIOUS INJURY. Use of this signal word is limited to the most
extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in
DEATH or SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in
MINOR or MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
SAFETY INSTRUCTIONS
Vestil strives to identify all foreseeable hazards associated with the use of its products.
However, material handling is dangerous and no manual can address every conceivable risk. Use
sound judgment whenever using this device.
Improper or careless use of this product could result in death or serious personal injuries.
•
Read and understand the entire manual before assembling, installing, using or servicing the
product.
•
Read the manual to refresh your understanding of proper use and maintenance procedures.
•
DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so
and
certain
that it will be safe to use afterwards.
•
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil.
Unapproved modifications automatically void the Limited Warranty and might make the product unsafe
to use.
•
DO NOT exceed the capacity of your rack. A single SHEET-R-57 has a capacity of 2,000 pounds
(909.1kg) per shelf and an overall capacity of 10,000 pounds (4,545.5kg).
•
DO NOT stack more than 2 SHEET-R-57 units. The overall capacity of the 2-unit stack is 16,000
pounds (7,272.7kg). Apply no more than 2,000 pounds per shelf. See
on p. 3-4.
•
Inspect the product at least once per month. Only use the rack if it is in
SATISFACTORY
CONDITION
. See
RECORD OF SATISFACTORY CONDITION
on p. .
A. DO NOT use this product if it is structurally damaged. Examples of structural damage include, but
are not limited to, the following: 1) Cracked, broken or significantly deformed load-bearing
members; 2) cracked welds; 3) corrosion, severe wear, or other condition that affects the integrity
of any part of the rack. Replace each part that fails to pass an inspection. DO NOT use the
product until it is fully restored to
SATISFACTORY CONDITION
.
B. DO NOT use the product if any unusual noise or movement is observed. If a malfunction occurs,
remove the unit from service and notify your supervisor & maintenance personnel about the issue.
•
DO NOT use this device UNLESS all labeling is easily readable from a reasonable, safe distance.
•
DO NOT shock load the rack. Gently and carefully apply and remove all loads from the rack.
Proper use, maintenance, and storage are essential for this product to function properly.
o
Always use this product in accordance with the instructions in this manual and consistent with any
training relevant to machines, devices, etc. used in conjunction with this product.
o
Keep the product clean & dry. Lubricate moving parts.