Rev. 9/28/2021
PRRJ-DOL, MANUAL
Copyright 2021 Vestil Manufacturing Corp. Page 4 of 5
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
Make a detailed record of the condition of each skate/dolly. Include observations about all features:
welds, frame elements, fasteners (bolts, nuts, washers, etc.) and casters/wheels. Thoroughly
photograph the unit from multiple angles so that all features are clearly imaged. Photograph all labels
applied to the product. Describe where each label is located. Collect all photographs and writings in a
single file. This file is a record of the product in satisfactory condition. Compare the results of each
inspection to this RECORD to determine if the unit is in satisfactory condition. Do not use a dolly unless
it is in satisfactory condition
INSPECTIONS AND MAINTENANCE
Compare inspection results to the
RECORD
. Do not continue to use the product unless every
component is in
SATISFACTORY CONDITION
. Cosmetic changes, like damaged paint/powder coat
do not constitute changes from satisfactory condition. However, touchup paint should be applied to all
affected areas as soon as damage occurs. Contact
TECHNICAL SERVICE
to order replacement
parts. Contact information is provided on the cover page of this manual.
Inspect the following at least once per month:
1. Surfaces – Check all surfaces of the product for dirt or other matter, especially fluids. Clean the
surfaces of the stand.
2. Hardware, fasteners – Examine hardware & fasteners (bolts, nuts, washers). Replace
damaged/worn hardware.
3. Examine the frame for wear, breaks, corrosion/rust, metal fatigue, and other forms of damage (e.g.
impact damage).
4. Labels– Replace labels that are damaged or not easily readable from a reasonable distance.
5. Overall structure – Examine the whole structure for rusting or metal erosion, rot, thinned regions. In
particular, examine pivot points, and ground-contacting elements. If rusting is purely superficial,
remove the rust/corrosion. Clean the affected area and apply touchup paint. If rusting, rot, or
thinning has weakened the material, contact
TECHNICAL SERVICE
for advice.
LABELING DIAGRAM
Label content and locations are subject to change so your product might not be labeled exactly as
shown. Compare this diagram to the RECORD. If differences exist between the diagram and the
RECORD, contact TECHNICAL SERVICE. Replace all labels that are damaged, missing, or not easily
readable (e.g. faded). To order replacement labels, contact the technical service and parts department
online at
http://www.vestilmfg.com/parts_info.htm
. Alternatively, you may request replacement parts
and/or service by calling (260) 665-7586 and asking the operator to connect you to the Parts
Department.
220
658
1153
