Vestil OLF-4-42, Instruction Manual, Page: 6 / 7

Table of Contents Rev. 11/11/2020 OLF-4 MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 6 of 7
remove it with a steel bristle brush or steel wool. Clean the affected area and apply touchup paint. If
rusting, rot, or thinning has weakened the material, contact TECHNICAL SERVICE for advice.
2.
Pins and fasteners:
Examine all pins (bale pin; height adjustment pin). Pins should be straight. Examine
retaining clips used to secure pins in place.
3. Bale assembly: Measure the length and width of the bale opening and connecting link. Make sure the
measurements match the measurements in the RECORD .
4. Forks: Thoroughly examine both forks. Look for cracks and severe wear. Confirm that each fork is solidly
welded to the frame.
5. Labels: Check all labels. Labels are shown in the LABELING DIAGRAM (below). Replace labels that are
missing, damaged, or not easily readable.
LABELING DIAGRAM
Label content and location are subject to change so your product might not be labeled exactly as shown.
Compare the diagram below with the RECORD . If you have any questions about labeling, contact
TECHNICAL SERVICE . Replace all labels that are damaged, missing, or not easily readable (e.g. faded).
To order replacement labels, contact the technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm . Alternatively, request replacement parts and/or service by calling
(260) 665-7586 and asking the operator to connect you to TECHNICAL SERVICE .
A: Label 991 B: Label 675
C: Label 531 D: Label 320
A
D
C
B