Table of Contents
Rev. 2/27/2020 HDOF, HDOS, FDOL, HDOSC, HDOR, HDOC, MANUAL
Table of Contents
Copyright 2020 Vestil Manufacturing Corp. Page 2 of 4
SIGNAL WORDS
This manual uses SIGNAL WORDS to direct the reader’s attention to important safety-related
messages. These messages describe uses of the product that could result in personal injury or property
damage. Each signal word corresponds to a specific hazard level. The following are definitions of signal
words that might appear in this manual
.
Identifies a hazardous situation which, if not avoided, WILL result in
DEATH or SERIOUS INJURY. Use of this signal word is limited to the most
extreme situations.
Identifies a hazardous situation which, if not avoided, COULD result in
DEATH or SERIOUS INJURY.
Indicates a hazardous situation which, if not avoided, COULD result in
MINOR or MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
SAFETY INSTRUCTION-
Vestil strives to identify all foreseeable hazards associated with the use of its products. However,
material handling is dangerous and no manual can address every conceivable risk. Ultimately, the most
effective way to prevent injury is to apply sound judgment whenever using this device.
Improper or careless use of this product could result in death or serious personal injuries.
•
Read and understand the entire manual before assembling, installing, using or servicing the
product.
•
Read the manual to refresh your understanding of proper use and maintenance procedures.
•
DO NOT attempt to resolve any problem(s) with the product unless you are both authorized to do so and
certain that it will be safe to use afterwards.
•
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil.
Unauthorized modifications automatically void the Limited Warranty and might make the product unsafe to
use.
•
DO NOT exceed the maximum rated load (see Label 287 on product).
•
Inspect the product before each use.
A. DO NOT use this product if the inspection reveals structural damage. Examples of structural damage
include, but are not limited to, the following: 1) Cracked, broken or significantly deformed load-bearing
members; 2) cracked welds; 3) corrosion, severe wear, or other condition that affects the ability of the
product to support weight or itself. Replace each part that fails to pass an inspection, and DO NOT use
the product until it is fully restored to normal condition.
B. DO NOT use the product if any unusual noise or movement is observed. If a malfunction occurs,
remove the unit from service and notify your supervisor & maintenance personnel about the issue.
•
DO NOT use this device UNLESS all product labels (see “Labeling Diagram”) are readable and
undamaged.
•
DO NOT use dollies on sloped surfaces. Only use a dolly on even, level concrete or asphalt.
•
Center loads on the dolly. Orient the load with the center of gravity inside as low to the ground as
possible. The center of gravity (CoG) should align with the center of the dolly. If the dolly leans/tips to one
side, then the CoG of the load item is outside the profile of the dolly, i.e. the triangle or square formed by
the casters of the dolly. Reposition the item to move the CoG inside the profile of the dolly.
•
DO NOT use the dolly to move an unstable load.
•
DO NOT attempt to balance multiple items on a dolly. Only move single/unitized items with the dolly.
Proper use, maintenance, and storage are essential for this product to function properly.
o
Always use this product in accordance with the instructions in this manual and consistent with any
training relevant to machines, devices, etc. used in conjunction with this product.
o
Keep the product clean & dry. Lubricate moving parts.
