Vestil CYL-P-LUG Series, Instruction Manual, Page: 2 / 7

Table of Contents Rev. 1/30/2020 CYL-P-X-LUG MANUAL
Table of Contents Copyright 2020 Vestil Manufacturing Corp. Page 2 of 7
SIGNAL WORDS
This manual uses SIGNAL WORDS to direct the reader’s attention to important safety-related
messages. These messages describe uses of the product that could result in personal injury or property
damage. Each signal word corresponds to a specific hazard level. The following are definitions of signal
words that might appear in this manual .
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY. Use of this signal word is limited to the most extreme
situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY.
Identifies practices likely to result in product/property damage, such as operation that
might damage the product.
SAFETY INSTRUCTIONS
Vestil strives to identify all foreseeable hazards associated with the use of its products. However,
material handling is dangerous and no manual can address every conceivable risk. Ultimately, the most
effective way to prevent injury is to apply sound judgment whenever using this device.
Improper or careless use of this product could result in death or serious personal injuries.
•
Read and understand the entire manual before assembling, installing, using, or servicing the
cylinder lifter. DO NOT operate this device until you read and understand the entire instruction manual.
Read the manual to refresh your understanding of proper use and maintenance procedures.
•
This device is designed for lifting compressed gas cylinders. DO NOT pull, drag, or slide the lifter
regardless of whether it is loaded or unloaded.
•
DO NOT modify the product in any way UNLESS you first obtain written approval from Vestil. Unapproved
modifications automatically void the LIMITED WARRANTY and might make the product unsafe to use.
•
DO NOT remove or obscure labels applied to the unit.
•
Inspect the product before each use.
•
DO NOT use this device UNLESS all labeling applied to the lifter is readable and undamaged. See
LABELING DIAGRAM on p. 6.
•
DO NOT use this lifter if it is damaged, malfunctioning, or missing parts.
•
This lifting device must only be used by designated persons and lifting device inspectors. Maintenance
and test personnel should only use this device when necessary to perform their duties.
•
DO NOT exceed the rated load/capacity of your lifter. Capacity figures are provided on product labeling.
See LABELING DIAGRAM on p. 6.
•
Only use the lifter to lift properly-sized gas cylinders. All cylinders loaded onto the lifter must be securely
strapped to the lifter with the ratchet straps. The straps must prevent all cylinders from being able to move
during the lift. Follow loading instructions in USING THE LIFTER on p. 4.
•
Make sure that all straps and chains are not kinked or twisted.
•
Distribute loads evenly on the lifter. The lifter floor must be substantially horizontal when the lifter is
elevated. Slowly raise the loaded lifter a few inches above the ground to determine whether the load is
distributed properly. Redistribute the load, if necessary, to achieve load balance.
•
Center the hoist above the lifting lug to minimize swing as the lifter rises off of the ground. DO NOT side
load the hoist.
•
Carefully eliminate slack in the hoist line before raising the lifter. Lift and lower the lifter slowly and
steadily. DO NOT suddenly lift or lower the lifter.
•
DO NOT lift loads any higher than necessary. Keep the suspended lifter as close to the ground as
possible while moving it.
•
Avoid obstructions while moving the lifter.
•
Stay clear of the lifter and load while the lifter is suspended. The lifter could swing or spin while elevated.
•
NEVER lift people or lift suspended loads over people.
•
DO NOT leave the lifter unattended while it is suspended. Land the lifter, unload it, and store the lifter in
its designated storage location before leaving it.
•
NEVER ride on the lifter.