Rev. 5/16/2014
CYL-H-4-KD, manual.doc
Copyright 2014 Vestil Manufacturing Co.
Page
4
of
8
Assembly instructions: to assemble the cabinet, perform the following steps.
[NOTE: Numbers in parentheses correspond to item numbers in the exploded parts diagram on p. 3.]
Step 1 – Fasten the back plate (6) to the side panels
(5) with
5
/
16
in. hardware (9, 10 and 11). The
back plate attaches to the outside of the side
panels.
a. Notice that one side of the back plate has only
2 bolt holes (there are three in each of the
other sides). This is the bottom side of the
back plate.
b. Also notice that each side panel has an edge
with 2 “hinge slots” cut out of it. This is the
front edge of a side panel.
c. Insert
a
5
/
16
in. – 18 x
3
/
4
in. bolt (9) through the
middle and bottom holes in the back plate and
the side panel as shown in the diagram to the
right.
d. Fasten the back plate to the other side panel
in the same manner. Do not tighten the bolts
and nuts at this time.
Step 2 – Attach the base plate (2) to the side panels
a. Look at the base plate and notice that on two edges notches are cut out of the corners. These are the front
and rear edges of the base plate. The front and rear edges are identical.
b. Set the base plate inside the assembly and align the large bolt holes in the plate with the bolt holes in the
flange of the side panels.
c. Place the cabinet in the location where it will be used. If you will anchor the cabinet to the ground, mark the
ground/surface with the locations of all 4 bolt holes. The bolt holes will accept
1
/
4
in. (diameter) anchor
bolts. Your building engineer should select anchor bolts of appropriate length.
Hinge slots in front
edges of side panels
Bottom side
of back plate
Back
plate (6)
Side
panel (5)
Side
panel (5)
Front / Back
edge
Bottom side of base plate
Top side of base plate
Front edge of
base plate
Anchor bolt hole
Anchor
bolt hole
LS
RS
RB
RB
RS
