Rev. 2/21/2018
CYL-D-1, MANUAL
Copyright 2018 Vestil Manufacturing Corp.
Page 2 of 6
Signal Words:
This manual uses SIGNAL WORDS to draw attention to uses of the product that could result in personal
injuries, as well as the probable seriousness of those injuries. Other signal words call attention to uses
likely to cause property damage. Signal words used in this manual appear below along with the definition of
each word.
Identifies a hazardous situation which, if not avoided, WILL result in DEATH or
SERIOUS INJURY. Use of this signal word is limited to the most extreme
situations.
Identifies a hazardous situation which, if not avoided, COULD result in DEATH or
SERIOUS INJURY
.
Indicates a hazardous situation which, if not avoided, COULD result in MINOR or
MODERATE injury.
Identifies practices likely to result in product/property damage, such as operation
that might damage the product.
Hazards of Improper Use:
Vestil strives to identify all foreseeable hazards associated with the use of this product. However, no
manual can address every conceivable risk. Ultimately, the most effective way to avoid injury when using
this device is to exercise good judgment and to always apply the following warnings.
Serious personal injuries and/or death could result if this product is used improperly or
carelessly.
Failure to read and understand the entire manual before assembling, installing, using or servicing the
product is misuse
.
This manual should be accessible to every person who uses the dolly.
Read the manual to refresh your understanding of proper use and maintenance procedures whenever
necessary.
DO NOT exceed the capacity (500 lb. (227.3 kg)).
Inspect the dolly as suggested in “Inspections & Maintenance” on p. 5. If the inspection reveals problems
with the dolly, DO NOT use the product until it is restored to normal condition. ONLY use manufacturer-
approved replacement parts. Contact Vestil’s technical service department if you are have any questions
about the condition of your dolly.
DO NOT use the dolly to transport any cylinder that does not seat securely in the retainers.
DO NOT transport a cylinder without using the retainer chains. Wrap the chains without slack around the
cylinder. Secure the chains in the latch slots.
When transporting a cylinder up-or-downhill, always remain uphill to the cylinder. Only move the dolly
across sloped terrain if you can easily control it.
DO NOT remove or cover any label. Every label must be readable and undamaged. (See “Labeling
diagram” on p. 5).
DO NOT modify the dolly in any way.
Unauthorized modifications automatically void the limited
warranty (see p. 6) and could make the dolly unsafe to use
.
