CART-500-LA Electric Table Truck
Specifications
Model:
CART-500-LA
Rate Capacity:
500 lbs/226kg
Lowest Height:
15”/400mm
Max. Height:
33”/840mm
Table Dimensions:
19½x32”/820x500mm
Battery Charger
110V-230V
Number of Cycles under full load
20
Warning & Safety Instructions
Insure that all employees understand and follow the following instructions.
Read and understand the owner’s manual before using or servicing the table.
Do not use the table if any damage or unusual noise is observed
Always watch the table and any load on it carefully when it is being moved or used
Avoid sudden stops or quick turns to prevent accidental tipping of the table.
Use caution if you slide a load onto the table top
Load must be centered and evenly distributed on the table
Do not perform any modifications to the table without manufacturer’s approval
Maintenance and repairs are to be done only by personnel qualified to perform the required work
Use only replacement parts supplied by the manufacturer.
RECEIVING INSTRUCTIONS
Every unit is thoroughly tested and inspected prior to shipment. However, it is possible that the unit
may incur damage during transit. If you see damage when unloading, make a note of it on the SHIPPER
RECEIVER.
Remove all packing and strapping material, inspect for damage. IF DAMGE IS EVIDENT, FILE A
CLAIM WITH THE CARRIER IMMEDIATELY! Also, check the platform size, type of power unit, etc.,
to see that the unit is correct for the intended application.
OPERATION INSTRUCTIONS
LOADING
The load rating in pounds is shown on the capacity tag on the platform. It indicates net capacity of the
table, assuming a centered load. Permanent damage to the table or injury to personnel could result from
exceeding the listed capacity.
Load size should not exceed the table dimensions and should not exceed twenty-four inches in height.
OPERATION
Press the “UP” push-button to raise the platform. Platform will raise only while the control is pressed.
Upon releasing the control, the platform will stop and hold its position.
Pressing the “DOWN” push-button will descend the platform. Again, releasing the control will stop the
platform movement and the unit will hold its position. Be certain no part of any person or object is under
any part of the platform before lowering the unit.
CART-500-LA
, Manual.doc
Page
2
of
6
Copyright 201
7
Vestil Manufacturing Corp.
