8/7/2019
ALL-T-2/4-GPT MANUAL
Copyright 2019 Vestil Manufacturing Corp.
Page 25 of 26
LABELING DIAGRAM:
The unit should be labeled as shown in the diagrams. However, label content and location are subject to
change so your product might not be labeled exactly as shown. Thoroughly photograph the unit when you
first receive it as discussed in the “Written Record” portion of the Inspections and Maintenance section on p.
5. Make sure that your record includes a photograph of each label. Replace all labels that are, or later
become, damaged, missing, or not easily readable (e.g. faded). To order replacement labels, contact the
technical service and parts department online at
http://www.vestilmfg.com/parts_info.htm
. Alternatively, you
may request replacement parts and/or service by calling (260) 665-7586 and asking the operator to connect
you to the Parts Department.
D: Label 287 On frame/oil tank
C: Label 206 On frame/oil tank close to oil fill cap
B: Label 207 On back of carriage cross bar
J: Label 661 (not shown in
diagrams) On transaxle
release lever (p. 7)
G: Label 835 On
frame by parking
brake
F
H: Label 696 On frame by motor
A: Label 220 On both legs and on drive belt guard (p. 8)
**New labels to provide the information mandated in part 8.5 of B56.6
are being created. When finished, they will replace labels B and D in
the diagram.**
E: Label 834 On kill
switch
F: Label 662
On handle by
direction
control lever
C
E
F
G
H
A
B
C D
A
G
A
H
