VESTEL AOB-9125W, User Manual

Page: 23 / 38

INSTALLATION AND PREPARATIONS FOR USE
Changing the gas inlet:
For some countries, the gas inlet type can be different for NG/LPG gases. In such a case, remove the
current connection components and nuts (if any) and connect the new gas supply accordingly. In all
conditions, all components used in gas connections should be approved by local and/or
international authorities. In all gas connections, refer to the “Assembly of gas supply and leakage
check” clause explained before.
Figure 12
Figure 11
Valve with flame failure device Valve with flame failure device
Bypass screw
Bypass screw
3.5. Electrical Connection Of Your Hob
During the electric connection, follow the instructions stated in the user manual.
• The earthing cable must be connected to the earth terminal.
• You have to ensure the power cord with suitable insulation to be connected to the power source
during the connection. If there is no appropriate earthed electric outlet in accordance with
regulations in the place where the appliance to be installed, contact to our authorized service.
The earthed electric outlet must be close to the appliance.
• Do not use an extension cord.
• The power cord must not touch to the hot surface of the
product.
• In case the cord is damaged, contact Authorized Service to
have it changed.
• Any wrong electric connection may damage your appliance,
as well as endangering your safety, rendering your guarantee
invalid.
• The appliance is adjusted for 230V 50Hz electricity. If the
mains electricity is different contact your authorized service.
Figure 13
L N
BR
O
W
N
GREEN
BL
U
E
• The supply cord should be kept away from hot parts of appliance. Otherwise, the cord may be
damaged, causing short circuit.
• The manufacturer declares that it has no responsibility against any kind of damages and losses
that are caused by improper connections that are performed by unauthorized people .
20