VESTEL AOB-3122, User Manual

Page: 19 / 30

Notes:
Flexible hoses can be used where the sited ambient temperature of the hose does
not exceed 70°C. These hoses must be manufactured in accordance with local
standards.
Gas hoses designed for natural gas MUST NOT be used for supplying LPG gas.
The hose should not be crushed or trapped or be in contact with sharp or abrasive
edges.
Using a suitable leak detection fluid solution check each gas connection one at a
time by brushing the solution over the connection.
The presence of bubbles will indicate a leak. If there is a leak, tighten the fitting and
then recheck for leaks.
IMPORTANT!
Do not use a naked flame to test for leaks.
CHANGING THE GAS INLET
During connection process the gas feeding manifold protruding from the back of
the hob must be visible completely, Any means connection (nut,hose etc.)must
be placed with attention to avoid any contact with parts that will heat up. It is
highly recommended to block the access to pipe connection, while the hob is in
use or when the gas supply is open.
. .
During the gas connection process, the pipe of the appliance should be kept
stationary, while the connected part (mechanical, LPG or NG nut) is fixed. Always
use the seals supplied in the spare set between the connection.
• Use ‘A’ for flexible hose connection of propane-buthane (LPG) type gases.
.
Use B type connection in Spain, Italy, Portugal, Greece, France and Algeria • ‘ ’
for use with flexible hose con ection n . .
16