English
- 10 -
Step 1 - Installing the Batteries to the
Remote
1.
Lift the cover on the back of the remote upward as
shown in the figure to the right.
2.
Install two AAA batteries. Make sure to match the
+ and - ends of the batteries to the diagram in the battery
compartment.
3.
Replace the cover.
+
+
- -
H
D
M
I 2
DVD / Cable Box /
Satellite receiver
etc.
Using Scart Connection
Using HDMI Connection
DVD / Cable Box / Satellite receiver etc.
Video camera, DVD player, etc.
Yellow:
Video connection
Red & White
: Audio connection
(Use to enable audio when
connectiong a PC).
Using AV Connection
Laptop PC, Desktop
PC. Use Side AV Audio
inputs to enable audio.
Using VGA Connection
Headphone Connection
Antenna Connection
Use to connect antenna.
HDMI Cable
VGA Cable
SCART Cable
RCA Cable
RF Cable
Headphone Cable
Using YPbPr to VGA Connection
You can use YPbPr to VGA cable for
enabling YPbPr connection. Note
that this cable is not supplied.
SCART
VGA
Step 2 - Control Switch
Programme/Volume / AV / Standby-On selection switch
Press the middle of the control button to switch on your TV.
You can move the switch, upward or downward to change the volume. If you want to change
channels, press the middle of the switch once (Position 3) and
then move upward or downward. If you press the middle of the switch once more,
source OSD will be displayed. To select desired source, move the switch upward
or downward and release. If you press the middle of the switch and hold about
a few seconds, the TV will switch to standby mode. Main menu OSD cannot be
displayed via control button.
Supported PC Input Typical Display Modes
The display has a maximum resolution of 1920 X 1080. Your TV may not support different resolutions. If you switch your
PC to an unsupported mode, a warning OSD will appear on the screen.
Specifications
RF AERIAL INPUT
75 Ohm (unbalanced)
OPERATING VOLTAGE
220-240V AC, 50 Hz.
AUDIO OUTPUT POWER (W
RMS.
) (10% THD):
2 x 6
POWER CONSUMPTION (W):
80 W (max) < 1 W (Standby)
PANEL
16:9 display, 32” Screen Size
DxLxH (With foot): 185 x 744 x 494
DxLxH (Without foot): 70 x 744 x 456
Transmission Standards:
VHF (BAND I/III) UHF (BAND
U) HYPERBAND
Step 3 - Connecting External Devices
Note: It is recommended that
the output resolution of a
connected device via the HDMI
input should be set to AUTO
(or original). If the connected
device does not include AUTO
(or original) resolution, selecting
576i for non-HD content is
recommended. If the connected
device does not include AUTO
(or original); or 576i options,
watcing non-HD content via the
Scart or Side AV connectors is
recommended.
