Vess R2000 SERIES, Product Manual

Page: 94 / 705

A
Bout
IP A
DDReSSeS
• “Default IP Addresses” on page 67
• “Choosing DHCP or a Static IP Address” on page 68
• “Accessing the MAC Address in the CLI” on page 69
• “Accessing the MAC Address in the CLU” on page 70
Choosing the appropriate IP addresses is essential to manage your Vess R2000 subsystem over a network. You
must change the IP addresses of the subsystems as required for your environment.
d
eFault
ip a
ddresses
The default virtual management port IP addresses are set to:
• IPv4 – 10.0.0.1
• IPv6 – 2001::1
The virtual management port IP address works with either RAID controller, enabling you to access a dual-
controller Vess R2000 over your network using a single IP address.
The default physical management port IP addresses are set to:
• Controller 1, IPv4 – 10.0.0.2
• Controller 1, IPv6 – 2001::2
• Controller 2, IPv4 – 10.0.0.3
• Controller 2, IPv6 – 2001::3
The physical management port IP address works with only one RAID controller. The port is used for management
of the subsystem and when a controller is in maintenance mode. See “Maintenance Mode” on page 626.
67
Product Manual Setup