VESPA S 125, Manual

Page: 38 / 80

To ensure the best functioning of the SAS system, the scooter should be taken to an
Authorised Service Centre to have the filter cleaned as indicated in the Scheduled
Maintenance Table.
The filter sponge should be cleaned with water and mild soap, then it should be dried
with a cloth and slight blows of compressed air.
WARNING
FOR THIS OPERATION, CONTACT AN AUTHORISED SERVICE CENTRE.
03_15
03_16
Checking the brake oil level (03_15)
The brake fluid reservoir is equipped with a sight glass « A » made of transparent ma-
terial; the quantity of liquid contained in the sight glass indicates the level of liquid in
the reservoir.
When the sight glass « A » is full, the level inside the reservoir exceeds the MIN level;
when it is partially full, the level drops to the MIN level; when it is completely empty,
the level of fluid in the reservoir is below the MIN level.
The brake fluid level may fall due to wear on the brake pads. In case the pad wear is
below the minimum mark, contact an
Authorised Service Centre to have the braking
system thoroughly checked.
Braking system fluid top up (03_16, 03_17, 03_18)
Proceed as follows:
1 . Remove the rear-view mirrors.
2 . Undo the two screws « A ».
3 . Undo the screw « B » and remove the front handlebar cover.
4 . Remove the reservoir cover « C » by loosening the two fixing screws « D » and refill
with the prescribed brake fluid type only and without exceeding the maximum level.
38
3 Maintenance