VESPA LX 4T USA, Workshop Manual

Page: 36 / 194

2 . Turn on the headlight and check that the bor-
derline of the projected light beam on the screen
is not lower than 9/10 of the distance from the
ground to the centre of vehicle headlamp and high-
er than 7/10;
3 . If otherwise, adjust the right headlight with screw
« A ».
N.B.
THE ABOVE PROCEDURE COMPLIES WITH THE EURO-
PEAN STANDARDS REGARDING MAXIMUM AND MINI-
MUM HEIGHT OF LIGHT BEAMS. REFER TO THE STATU-
TORY REGULATIONS IN FORCE IN EVERY COUNTRY
WHERE THE vehicle IS USED.
CO check
The check may be necessary in the event of irreg-
ularities in the engine performances, or when ad-
justing the engine idle speed.
- The test must be carried out only after having
carefully cleaned all carburettor components with
the air filter clean and the spark plug in good con-
ditions.
1) Warm up the engine by riding the vehicle for
about 5-10 minutes, as this is the time required for
the choke device to disengage.
2) Shut down the engine only for the time required
to carry out operations 3) and 4).
3) Remove the RH side fairing and the SAS box
cover by loosening the 3 screws shown in the fig-
ure. Interpose a plastic sheet between the secon-
dary air one-way valve and its housing on the
cover. Ensure the valve gasket seals properly. Re-
fit the SAS box cover.
4) Fit the special tool for the collection of exhaust
gases as shown in the picture. Pay attention in en-
suring the seal between the exhaust pipe and the
collection tube. Insert the gas analyser and the ex-
haust tube.
5) Insert the multimetre thermometer inside the
sump, through the oil filler hole.
Maintenance
LX 4T USA
MAIN - 36