Vertiv™ XTE PTS Series PEIL/PESB Power Transfer Switches Description & Installation Manual
12
6.
Torque between 500 and 550 inch-pounds (56.54 and 62.2 Kilogram-Meters).
7.
Have a licensed electrician complete the electrical hookup to the power meter and to the load center according to electrical
codes and procedures. Refer to the wiring diagram in
, which is also located on the inside of the cabinet door, for
interior wiring connections.
8.
After the wiring is complete, fill the pad opening with pea gravel until flush with the top of the pad.
9.
Close the door and secure it.
7
Mounting the Cabinet on a Pole
DANGER!
ELECTRICAL HAZARD
Do not install the cabinet during a thunder storm. All power must be turned off before removing inner barrier panels.
To avoid possible injury or damage to equipment, follow all local safety practices and wear appropriate safety gear when
installing the cabinet on a pole.
7.1
Pole-Mount Kits
Standard pole-mount kits must be ordered separately. These kits are designed for use on wooden poles. The part numbers for the
pole-mount kits are as follows:
•
Brown: PEIL-PB-Kit
•
Off-White: PEIL-PI-Kit
•
Green: PEIL-PG-Kit
NOTE!
Mounting hardware is not provided. You must supply two 1/2-inch (1.27 cm) bolts suitable for the pole size.
7.2
Height on Pole
The cabinet can be installed at any height on the pole. For ease of access, install the cabinet at working level or in accordance with
local practices.
NOTE!
Make sure that there is enough clearance to maintain the minimum bend radius of the cable to be installed.
7.3
Pole Installation
Perform the following steps to install a XTE PTS Series PEIL/PESB Power Transfer Switch on a pole using a standard pole-mount kit:
1.
Unpack the pole-mount kit and the cabinet.
2.
Verify that the Pole-Mount kit contains the following components (as shown in Fig. 8):
•
a two-point pole-mount channel,
•
two aluminum washer plates,
•
two rubber gaskets to be installed between the cabinet and the aluminum washer plates, and
•
a solid bottom.