Vertiv
|
NetSure 502NGFB Installation Manual (Section 6009)
|
Rev. Z
54
Installing the Rectifier Modules
The Rectifier Module is hot swappable. It can be installed with the system operating.
as this procedure is performed.
Procedure
1.
Place the Rectifier Module into an unoccupied mounting slot without sliding it in completely.
2.
Loosen the captive fastener securing the top of the latch mechanism to the front of the Rectifier
Module. Pull the top of the latch mechanism away from the Rectifier Module (this will retract the latch
mechanism located on the underside of the Rectifier Module).
3.
Push the Rectifier Module completely into the shelf. Push the top of the latch mechanism into the front
panel of the Rectifier Module, and secure by tightening the captive fastener. This locks the Rectifier
Module securely to the shelf.
4.
Repeat the above steps for each Rectifier Module being installed in the system.
5.
After the Rectifier Modules are physically installed in the mounting shelf(s), they are ready for operation
immediately after power is supplied to them.
Figure 23:
Latch Mechanism on the Rectifier Module
Latch Mechanism
Captive Fastener
