Vertiv Liqui-tect LP6000, Installer/User Manual, Page: 26 / 82

4.6.1 Using the Keyboard and Selecting Settings
When settings are selected for configuration, a selection screen or keyboard opens.
The keyboard displays the configuration setting as shown in the following figure. Use the keyboard to
enter the setting.
NOTE: For some settings, the configuration is selectable. Use the Up/Down buttons to highlight the
setting, then touch
Select
.
Figure 6.2 Keyboard
ITEM DESCRIPTION
1 Configuration setting
2 Backspace, deletes the entry.
3 Escape, returns to the previous screen without saving.
4 Enter, accepts entry/saves changes.
4.6.2 Configuring Leak Settings on the Touchscreen
The Leak Settings configure system variables including leak and contamination thresholds, latching and
un-latching alarms, and leak-detection cable resistance.
To access leak settings:
1. On the LCD display, touch
Setup
, enter a password if needed, and touch the enter key.
The Setup menu opens.
2. Touch
Up
/
Down
to highlight Leak Settings, and touch
Select
.
The Leak Settings menu opens.
3. Touch
Up
/
Down
to highlight the setting to configure (described in the following table), and
touch
Select
.
See Using the Keyboard and Selecting Settings on page 26 to update the setting.
Vertiv | Liqui-tect LP6000 Installer/User Guide | 26