Vertiv Liebert XDO, User Manual

Page: 28 / 47

Vertiv ™ | Liebert® XDO | User Manual 22
ITEMS DESCRIPTION ITEMS DESCRIPTION
1 Rocker switch 3 Indicator light
2 Connector
Figure 3-3 Low Voltage Device Layout Diagram
3.2.2. Connection of Unit Power Supply Cables
The specific location of the power interface of the Vertiv ™ Liebert® XDO terminal unit is shown in Figure 3-1 . L, N, and PE are
connected to the corresponding ends of the external power supply. Leave a certain margin for the incoming cable and fix it
on the cable fixing clamp, which is fixed on the inner panel of the unit. The top inlet/outlet holes and the bottom inlet holes
are shown in Figure 3-4.
Refer to the rated full load current value (FLA) of the unit for the selection of cabling model, Table 3-1 provides the FLA
values of the unit.
Table 3-1 Full Load Current Value of the Unit (unit: A)
Model Standard Unit
XDO020CS15HC 4
Note: The cable size should comply with local and national regulations.