Vertiv I Liebert Air Cooled Condenser I User Manual
8
Figure 2-2 Crane lifting
Unpacking
Remove the timber frame package and foam of the condenser but reserve the protection
cardboard of fins. The protection cardboard of fins and the cushion pad of U tube located at
the end of the condenser should be removed after the condenser is in its installation position.
1. If the condenser is to be placed horizontally, you should complete the installation
of legs while the condenser is located vertically.
2. When moving the condenser by hand, to avoid distortion and system leakage, do
not touch the copper pipes.
Inspection
After the product arrival, you should check the accessories against the packing list. If any parts
are found missing or damaged, please report to the carrier immediately. If any covert damage is
found, please report to the carrier and the distributor immediately.
2.2
Installation Notes
The installation notes of the condenser are as follows:
1. To ensure the heat dissipation capacity, install the condenser in the place with smooth
airflow. Do not install it where the coil of the condenser may be obstructed by dust or snow.
Ensure that there is no steam or waste heat around.
2. If possible, the horizontal installation is recommended to reduce the noise.
3. The condenser should be installed away from the residential areas (≥ 15m).
