3.1 Moving the Unit
It is recommended to use mechanical transport equipment such as forklift or crane when unloading and transferring the
condenser closest to the installation site.
When a forklift is used, insert the tines of the forklift in the direction as shown in the figure below.
Figure 3.1 Inserting the Forklift in this Direction
3.2 Unpacking the Unit
Unpacking the Condenser
1.
Pull straight the hooks on the top and side wooden panels using a claw hammer.
2.
Remove the top and side wooden panels and foam from the condenser. Do not remove the protection
cardboard of the fins until the condenser is in its installation position.
Unpacking the Low Ambient Kit
1.
Pull straight the hooks on the top and side wooden panels using a claw hammer.
2.
Remove the top and side wooden panels from the low ambient kit. Loosen the clamp that secures the kit to the
bracket and then remove the kit.
3 Pre-installation Preparation
10
Vertiv™ Liebert® CRV CCD25 and CCD35 Condensers User Manual
