Vertiv™ XTE 601E Series Equipment Enclosures Description and Installation Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
62
8.
Remove all block-end covers (front and back) to access battery block terminals.
Figure 13.4 Removing Block-end covers to Expose Terminals
9.
Measure and record on the SAFT Installation Instruction Sheet 80-94890-02 I/O sheet all block voltage readings.
10.
Remove all end-terminal bolts and wave washers used to connect the blocks and apply No-Ox to terminals surface.
11.
Attach long interblock connector to negative terminal of Block 3. Protect front-end with electrical tape or other insulating
material before handling battery block.
NOTE!
Torque at 96 in-lbs and apply No-Ox to all exposed metal surface.
12.
Place blocks 1, 2, 4, and 5 inside the battery shelf. See Figure 13.5.
Figure 13.5 Placing Blocks 1, 2, 4 and 5 on Battery Shelf
Exposed terminals
after removing the
block end-covers
NOTE: The image shown is from other SAF T battery installations.
Use for reference only.
1
2
3
4
5
