Vertiv™ NetSure™ IPE Series -48 VDC Outdoor Rectifier Installation and User Manual
Proprietary and Confidential © 2022 Vertiv Group Corp.
22
2.4
Mounting the Rectifier to a Pole or Wall Using the Standard Rectifier
Mounting Kit
2.4.1
General
The rectifier can be pole mounted or secured to a suitable wall using the standard rectifier mounting kit. See “Mounting Kits” on
page 20.
•
For wall mounting, the customer needs to supply four (4) wall anchors capable of supporting the weight of the rectifier.
NOTE!
If the rectifier’s front access panel is opened during installation, ensure the access panel is securely closed and
the screws are torqued to 2.5 Nm.
2.4.2
Pole Mounting Procedure
NOTE!
Torque all hardware to the values shown in the illustrations.
1.
Unpack the rectifier and mounting accessories and kits.
2.
Install the mounting bracket (63240ETT) in the appropriate top position on the pole with the supplied pole mount band.
Securely tighten the pole mount band to the pole. The pole mount band accommodates poles from 60mm to 120mm in
diameter. Refer to Figure 2.4.
3.
Install mounting brackets to the rear panel of the rectifier with the supplied hardware (do this on the ground first). Refer
to Figure 2.5 and Figure 2.6.
4.
Secure the top of the rectifier to the pole by securing the mounting bracket (63240ETS) to the mounting bracket
(63240ETT) with the supplied M6 bolts. Refer to Figure 2.7 and Figure 2.8.
5.
Secure the bottom of the rectifier to the pole by securing the mounting bracket (63240ETT) to the pole with the
supplied pole mount band. Refer to Figure 2.9 and Figure 2.10.
Figure 2.4 Installing the Mounting Bracket to the Pole with the Pole Mount Band
Pole
Pole mount band
P/N:63123652
Torque: 5 N
·
m
Mounting bracket
P/N:63240ETT
