PWC – 1800
PureWaterCooler
Copyright 2011 Vertex Water Products
6.1 Remove top cover of cooler (section 3)
6.2 Remove control panel and front panel (as done i
n
section 5)
6.3 Remove (1) screw for solenoid mounting plate.
6.4 Remove (2) silicon tubes from solenoids.
6.5 Remove (2) solenoid connectors from control board.
6.6 Remove (4) mounting screws and remove mounting
plate.
6.7 Slide solenoid off of manifold.
6.8 Reassemble in reverse order.
Make note of the following:
a. Water flow through the solenoid is directional.
There is an arrow molded in the side of the solenoid body
showing water flow direction. Make sure the solenoid is
oriented correctly. Water can leak from the solenoid if not
installed correctly.
b. When installing electrical connectors into the
circuit board please note: the red female connector on the
board connects to the red male connector (hot solenoid)
and the blue female connector on the board connects to the
white male connector with one blue wire (cold solenoid).
6. Dispensing Solenoid – Remove/ Replace