5
VXR-9000E FM R
EpEatER
O
pERating
M
anual
Programmable Function
(
PF
)
Key Details
S
can
Press (or Press and hold in for one second) the
PF
key assigned to “Scan” to start scanning. To stop
scanning, press (or Press and hold in for one second)
this key again.
The scanning feature is used to monitor multiple
channels programmed into the repeater.
This function is only activated on the “
Base Trans-
ceiver
” mode.
S
quelcH
Press (or Press and hold in for one second) the
PF
key assigned to “Squelch” to override the Squelch
action (CTCSS, DCS, and Noise Squelch), so as to
hear any signal present on the operating channel.
t
eSt
t
one
Press (or Press and hold in for one second) the
PF
key assigned to “Test Tone” to generate the Test Tone
Signal, as programmed by your Vertex Standard
dealer.
Press (or Press and hold in for one second) this key
again to stop the generation of the Test Tone. This is
a toggle function.
Press (or Press and hold in for one second) this key
while press and holding the
PTT
switch to transmit
the Test Tone Signal, as programmed by your Vertex
Standard dealer.
t
eSt
t
one
M
This function provides momentary generation of the
above-referenced Test Tone signal, so long as the
PF
key assigned to “Test Tone M” is pressed and held
in.
Press this key while press and holding the
PTT
switch to transmit the Test Tone Signal, as pro-
grammed by your Vertex Standard dealer.
tot
Press (or press and hold in one second) the
PF
key
assigned to “TOT” to turn the Time-Out Timer fea-
ture “On” or “Off” (toggle).
When the TOT feature is set to “On,” the repeater
will return to the “Receive” mode automatically after
a preset time of continuous transmission (determined
via programming by your Vertex Standard dealer).
t
RanSMit
Press (or Press and hold in for one second) the
PF
key assigned to “Transmit” to enable (“On”) or dis-
able (“Off”) the transmission of the
VXR-9000E
.
tX p
oWeR
M
iD
Press (or Press and hold in one second) the
PF
key
assigned to “TX Power Mid”to set the transmitter
power to the “Mid” level.
Press (or press and hold in one second) this key
again to return to the “Original” power level (deter-
mined via programming by your Vertex Standard
dealer).
This function is ignored on the channel which is pro-
grammed to the transmitter power to the “Mid” or
“Low” level by your Vertex Standard dealer.
tX p
oWeR
l
oW
Press (or Press and hold in one second) the
PF
key
assigned to “TX Power Low”to set the transmitter
power to the “Low” level.
Press (or press and hold in one second) this key
again to return to “Original” power level (determined
via programming by your Vertex Standard dealer).
This function is ignored on the channel which is
programmed to the transmitter power to the “Low”
level by your Vertex Standard dealer.
