Vertex Standard VM-3500E, Owner'S Manual

Page: 40 / 68

VM-3500E Page 40
for the acknowledgment. If the reply signal is not re-
ceived, the transceiver will transmit again.
8. After the second INDIVIDUAL CALL is transmitted, if
the reply signal is not received, the display will be as
shown in the illustration on the right. To send the call
again, press the [
ENT
] key.
9. When an individual call acknowledgment is received,
the established channel is automatically changed to
the channel which is selected on step 5 above and a
ringing tone sounds.
10. Press the any key to listen to the channel to make
sure it is not busy, then key the microphone and call the other vessel you
desire to communicate with.
Manual Calling
You may enter an MMSI number manually to contact without the Setting up the
Individual Directory.
1. Press the [ CALL
(
MENU
)] key. The “
DSC Operation ”
menu will appear.
2. Turn the CHANNEL selector knob to select “
Indi-
vidual
.” (To cancel, select “
Exit
” with the CHANNEL
selector knob or press the [ 16/9
] key.)
3. Press the [ ENT
] key. The transceiver will beep, and
the “Individual directory” will appear.
4. Turn the CHANNEL selector knob to select “ Manual ,”
then press the [ ENT
] key.
5. Enter the MMSI number (nine digits) which you want
to contact by the keypad, then press the [ ENT
] key.
6. Turn the CHANNEL selector knob to select “ Manual ,”
then press the [ ENT
] key.
7. Enter the operating channel which you want to com-
munication by the keypad, then press the [ ENT
] key.
8. Press the [ ENT
] key again to transmit the individual
DSC signal.
9. After INDIVIDUAL CALL is transmitted, the trans-
ceiver will wait 8 seconds for the acknowledgment. If
the reply signal is not received, the transceiver will
transmit again.
10. After the second INDIVIDUAL CALL is transmitted, if the reply signal is not
received, the display will be as shown in the illustration on the right. To send