Vertex Standard HX850S, Alignment Manual

Page: 4 / 6

FCC ID: K6630313X3D0
IC ID: 511B-30313X3D0
Alignment
4/6
Vertex Standard Co., Ltd.
Overview of the Alignment Mode
The alignment mode has been built in the microprocessor in order to adjust the
performance of transceiver.
Starting the alignment mode
Set the channel to CH16 and then press the [ PWR ] switch while press and holding the
[ DISTRESS ] and [ CALL ] keys.
Adjustment of PLL frequency
ˆ
Connect the frequency counter to the antenna jack.
ˆ
Press the [ SCAN/DW ] key till “ 00:M REF ” is displayed.
ˆ
Press [
▲
] or [
▼
] keys while pressing the [ PTT ] key to set the frequency to
156.80000MHz ± 100Hz.
ˆ
Press [ CALL/ENT ] key to fix the alignment data.
Adjustment of TX High Power
ˆ
Connect the wattmeter and 50-ohm dummy load to the antenna jack.
ˆ
Press the [ SCAN/DW ] key till “ 02:Hi Po ” is displayed.
ˆ
Press [
▲
] or [
▼
] keys while pressing the [ PTT ] key to set the power to 6.0 ± 0.1W.
ˆ
Press [ CALL/ENT ] key to fix the alignment data.
Adjustment of TX Mid2 Power
ˆ
Connect the wattmeter and 50-ohm dummy load to the antenna jack.
ˆ
Press the [ SCAN/DW ] key till “ 03:Mid2 Po ” is displayed.
ˆ
Press [
▲
] or [
▼
] keys while pressing the [ PTT ] key to set the power to 5.0 ± 0.1W.
ˆ
Press [ CALL/ENT ] key to fix the alignment data.
Adjustment of TX Mid1 Power
ˆ
Connect the wattmeter and 50-ohm dummy load to the antenna jack.
ˆ
Press the [ SCAN/DW ] key till “ 04:Hi Po ” is displayed.
ˆ
Press [
▲
] or [
▼
] keys while pressing the [ PTT ] key to set the power to 2.5 ± 0.1W.
ˆ
Press [ CALL/ENT ] key to fix the alignment data.
Adjustment of TX Low Power
ˆ
Connect the wattmeter and 50-ohm dummy load to the antenna jack.
ˆ
Press the [ SCAN/DW ] key till “ 05:Lo Po ” is displayed.
ˆ
Press [
▲
] or [
▼
] keys while pressing the [ PTT ] key to set the power to 0.8 ± 0.1W.
ˆ
Press [ CALL/ENT ] key to fix the alignment data.