Vertex Standard EVX-5300, Operating Manual, Page: 14 / 20

EVX-5300 O
pErating
M
anual
12
a
dvanced
o
peratIon
d
ual
w
atcH
The Dual Watch feature is similar to the SCAN feature, except that only two chan-
nels are monitored:
o
The current operating channel; and
o
The Priority-2 channel.
To activate Dual Watch :

Press (or press and hold) the assigned
PF
key.

The scanner will search the two channels; it will pause each time it finds a
channel on which someone is speaking.
To stop Dual Watch :

Press (or press and hold) the assigned PF key.

Operation will revert to the “Dual Watch Start” channel.
Fm-s
can
(
F
ollow
-m
e
s
can
)
The FM-Scan feature checks a User-assigned Priority Channel regularly as you
scan the other channels. Thus, if only Channels 1, 3, and 5 (of the 8 available
channels) are designated for “Scanning,” the user may nonetheless assign Channel
2 as the “User-assigned” Priority Channel via the FM-Scan.
To activate the FM-Scan, first select the channel you want to designate as the
“User-Assigned Priority Channel” and press (or press and hold) the assigned PF
key. Then press (or press and hold) the Channel Up/Down key (generally the [

]/
[

] key) to recall to the “Scanning Start” channel which has been programmed by
your dealer to activate the scanner. When the scanner stops on an “Active” chan-
nel, the User-assigned Priority Channel will automatically be checked every few
seconds; if activity is found on the User-assigned Priority Channel, the radio will
switch between it and the Dealer-Assigned Priority Channel, if any.
s
can
s
et
Press (or press and hold) the assigned PF key to add/delete the current channel to/
from your scanning list.
When you delete channel, the Transceiver Status Indicator (“
A ”, “ B ” or “ C ”) will
turn off, if the “ SCAN CH ” status is assigned to one of the Transceiver Status
Indicator. To restore a particular channel to your scanning list, press (or press and
hold) the assigned PF key again; the Transceiver Status Indicator will illuminates,
if the “
SCAN CH
” status is assigned to one of the Transceiver Status Indicator.
When the scanner is stopped, you may remove the channel from the scan list tem-
porarily by pressing (or press and holding) this key.