Vertex™
Filter Sock Instruction Manual
©Vertex Aquaristik ™ 2018
P
ag
e
-
2
-
inner tube diameter to ensure no media particles will get through. Push the foam disc down
using a large rod.
5-
Fill the inner chamber assembly with media
6-
Assemble the upper perforated plate over the inner chamber and fasten in place using the
onboard Titanium Screw. If the foam dis is required, it is best to place over the inner tube prior
to installing the upper perforated plate. Refrain from over tightening which can possible damage
the threading. Damaged threading, if cause by negligence or improper installation, will not be
covered under warranty.
7-
Place the inner chamber assembly back inside the unit.
8-
Place the lid over the inner tube assembly and ensure alignment with the middle tube port of
the lid. Once close, the O-ring on the tube will create a sealed connection. Small amount of food
grade silicone lubrication can be used to ensure proper seal.
9-
Close the lid turning clockwise. Make sure the middle tube is being properly driven inside the
port.
10-
Vertex ™ Rx
-U reactors are fit to be utilized both in sump and/or with external applications.
Choose the reactors location carefully and measure the length of tubing required to install your
reactor.
11-
Rx-U reactors are designed to be either hard plumbed to your system or used remotely via hose
or soft tubing. A pair of barbed hose connections are supplied to accommodate such installation
and use.
12-
If you desire to use the reactor remotely, use PVC cement to permanently glue the barbed
connections to the union and union ball valve. Use proper sized soft tubing or a hose. Inserting
the end of the hose in hot water for a few seconds will make the material softer and installation
easier. Ultimately, small amounts of food grade lubrication can be used to slip the hose over.
Use hose clamps to secure the connections.
13-
Check the lid and all the connections to make sure they are properly installed and seated.
14-
Attached the feed-line to the ball valve connection to avoid pressurizing the reactor. Excess
pressure can damage our reactor. Such damages are not covered under warranty.
15-
Attach the exit line to the union connection. Find an adequate place for the exit line in your sump
or aquarium.
16-
Open the valve and let the reactor fill with water. Once filled, close the valve for a few seconds
to let the media settle.
17-
Once the media is settled, slowly open the valve and adjust the flow rate according to the
media’s requirement and/or manufacturers
guidelines.
Warning: To avoid damage to property, livestock and/or personal injury, please follow all these
instructions and/or consult with a professional. Vertex Aquaristik™ will not be held accountable for any
damaged the misuse and/or improper installation of the unit may cause.
