7
www.versitron.com
CAUTION!
The transmitter unit contains a light-emitting diode located in the optical connector. This device emits
invisible infrared electromagnetic radiation that can be harmful to human eyes. The radiation from this
optical connector, if viewed closely without any protection, may cause instantaneous damage to the retina
of the eye. Direct viewing of this LED should be avoided at all times.
SECTION 2
INSTALLATION INSTRUCTIONS
FIGURE 2: PSACV1 Power Supply FIGURE 3: VCA1100 Data Cable
INSTALLATION PROCEDURE
The VersiVision FVT1100 and FVR1100 Series fiber optic video modems can be used with RS-485/RS-422
and RS-232 data protocols. Simply set the mode of operation with the internal DIP switches and then connect
the signal, power supply, and fiber optic cables between the two units. There are indicator LEDs on the units for
monitoring the real-time status of video, power, and data. The following instructions describe the typical
installation procedure and the function of the LED indicators located on each unit.
1.
Connect the video source (camera) to the video input BNC connector on the FVT1100 transmitter unit
using coaxial cable.
2.
Connect the video output BNC connector on the FVR1100 receiver unit to the video monitor using
coaxial cable.
3.
Connect the fiber optic cable between the transmitter and receiver devices.
4.
See page 8 for instructions on connecting the data cable
5.
Apply the power supply to both the transmitter and receiver using the PSACV1 power supply provided.
Note: If using any of the FVR1100M modules, power is provided from the integral power supply of the
FVC14 chassis.
6.
When the power is applied, the red POWER LED will light, indicating the presence of operating power.
The green VIDEO LED and the blue DATA LED will give an indication as stated in the following page.
7.
The link should now be operational.
