7
SECTION 2
INSTALLATION INSTRUCTIONS
INSTALLATION PROCEDURE
The VersiVision FVT1000 Series transmitters and receivers are preset for immediate use. There are indicator
LEDs on the units for monitoring the real-time status of video, and power. The following instructions describe
the typical installation procedure and the function of the LED indicators located on each unit.
1.
Connect the video source (camera) to the video input BNC connector on the FVT1000 transmitter unit
using coaxial cable.
2.
Connect the video output BNC connector on the FVR1000 receiver unit to the video monitor using
coaxial cable.
3.
Connect the fiber optic cable between the transmitter and receiver devices.
4.
Apply power to both the transmitter and receiver using the PSACV1 power supplies provided.
Note: If using any of the FVR1000M modules, power is provided from the integral power supply of the
FVC14 chassis.
5.
When the power is applied, the red POWER LED will light, indicating the presence of operating power.
The green VIDEO LED will give an indication as stated in the following page.
6.
The link should now be operational.
FIGURE 2:
PSACV1 Power Supply
INDICATOR LEDs
The stand-alone units have integral LEDs that are used to monitor the state of the unit. There are two video
LEDs and two power LEDs on the units.
TRANSMITTER and RECEIVER
Power: ON: (Red) indicates that correct power has been applied.
Transmitter
:
Video: OFF: Indicates no video detected on input BNC connector
(No Video present on input BNC)
ON: Indicates video detected on input BNC connector
(Video present on input BNC connector)
Receiver
:
Video: OFF: Indicates no video detected on output BNC connector
(No video present on output BNC)
ON: Indicates video detected on output BNC connector
(Video present on input BNC)
All manuals and user guides at all-guides.com
