background image

gtcocalcomp.com

VersaTable and GTCO Digitizer Assembly Guide

1.

Assemble the VersaTable

To assemble the VersaTable, follow Steps 1 - 6 in the included VersaTable Assembly Guide, but skip Step 5. The
Assembly Guide refers to the ‘main surface’. However, the ‘main surface’ is not included because the GTCO Digitizer
will act as the main surface. You will connect the GTCO Digitizer in Step 3 below.

2.

Attach the Universal Mounting Brackets (UMB) to the VersaTable

A. After completing Step 6 in the VersaTable Assembly Guide, you will now attach the

other end of the Tilt Mechanism to the Angle Back Support. Insert a bolt, washer, and
nut through the inner holes of the Tilt Mechanism and the corresponding holes of the
Angle Back Support.

B. Place the two UMBs perpendicular across the Pencil Tray and the Angle

Back Support.

One UMB will go over the Pencil Tray slot that is farthest to the left.

The other UMB will go over the slot that is farthest to the right.

C. Attach the UMBs to the Pencil Tray using two of the supplied bolts, washers, and nuts. Do not tighten.

D. Attach the UMBs to the Angle Back Support and the outer holes of the Tilt Mechanism

using two of the supplied bolts, washers, and nuts.

E. Place the rubber bumpers on the Cross Support under the UMBs.

F.

Tighten all bolts.

3.

Attach the GTCO Digitizer to the UMBs

The digitizer is attached to the UMBs with the four supplied Thumbscrews. The Thumbscrews
are threaded through the holes in the end tabs on the UMBs and screwed into the sliding T-Nuts
in the top and bottom channels of the Digitizer frame.

A. Center the Digitizer over the UMBs.

B. Slide the T-Nuts into place so they line up with the holes in the end tabs of the UMBs.

C. Screw a Thumbscrew through each UMB end tab and into the receiver T-Nut.

37-01883-01| 36-01924

Attached Kit Contents

6 x ¼”-20x1” bolt

6 x ¼” split lockwasher

6 x ¼” flat washer 

6 x ¼”-20 nut

4 x Thumbscrews

Reviews: