16
햴
LIGHTING THE GAS GRIDDLE BURNER FITTED WITH FLAME
FAILURE SAFETY DEVICE
In order to light the burner, you must:
1 - With the griddle plate correctly installed push and turn the knob in an anti-clock-
wise direction up to the
position (maximum rate), push in and hold the knob
until the flame has been lit (fig. 3.5).
The sparks produced by the lighter positioned on the burner will light the flame.
Check the ignition of the burner by looking through the opening between the bot-
tom side of the griddle plate and the cooktop.
In the event that the local gas supply conditions makes it difficult to light the burn-
er in
position, try again with the knob in
position.
Never continue this operation for more than 15 seconds. If the burner has still not
ignited, wait for about 1 minute prior to repeating the ignition.
If after 2-3 times the burner has still not ignited do not repeat the lighting proce-
dures but remove the griddle plate (if hot, let it to cool) from the range cooktop (by
using suitable protective gloves) and wait for about 10 minutes prior to repeating
the ignition starting from above step 1.
2 - Wait for about ten seconds after the gas burner has been lit before letting the knob
go (safety device activation delay).
3 - If there is no mains electrical supply:
a - Remove the griddle plate (if hot, let it to cool) from the cooktop by using suit-
able protective gloves.
b - Push and turn the knob in an anti-clockwise direction up to the
position
(maximum rate) and bring a lighted match close to the right and left side of the
burner. Pay special attention to burner flames: do not lean over the burner.
c- In the event that the local gas supply conditions makes it difficult to light the
burner in
position, try again with the knob in
position.
d - Keep the knob pressed (fig. 3.5).
Never continue this operation for more than 15 seconds. If the burner has still
not ignited, wait for about 1 minute prior to repeating the ignition.
If after 2-3 times the burner has still not ignited do not repeat the lighting pro-
cedures but wait for about 10 minutes prior to repeating the ignition starting
from above step 3-a.
e - Wait for about ten seconds after the gas burner has been lit before letting go
the knob (safety device activation delay).
f - Re-fit the griddle plate in its housing by using suitable protective oven gloves.
Pay special attention to burner flames.
g - Check the operation of the burner by looking through the opening between the
bottom side of the griddle plate and the cooktop.
4 - Adjust the flame to the desired position.
If the burner flame should go out for some reason, the safety valve will automatically
stop the gas flow.
To re-light the burner, return the knob to the closed position, wait for at least 1 minute
and then repeat the lighting procedure. If your local gas supply makes it difficult to light
the burner with the knob set to maximum, set the knob to minimum and repeat the
operation.
Caution!
The range becomes very hot during operation.
Keep children well out of reach.
