3
Blue LED
Indicates charging status when Go Wireless Link is connected to the Charging Cable
or Charging Station.
On – charging in progress
Off – charging is complete
Red LED Flashing
Indicates Go Wireless Link is awake and ready to connect.
Green LED Flashing
Indicates Go Wireless Link is connected and taking data.
Red and Green LED Off
Indicates Go Wireless Link is in the lowest power sleep mode.
Collecting Data
Connect a compatible sensor to Go Wireless Link. For a list of compatible sensors,
see www.vernier.com/gw-link
Collecting Data with Graphical Analysis App
1. Press the power button on Go Wireless Link to turn it on. The LED on
Go Wireless Link will flash red.
2. Open Graphical Analysis.
3. Tap Create Experiment and choose Wireless Sensors.
4. Select Go Wireless Link from the list of available sensors. When paired with the
software, the LED on Go Wireless Link will flash green.
5. Collect data as desired.
Collecting Data with LabQuest 2 App
1. Press the power button on Go Wireless Link to turn it on. The LED on
Go Wireless Link will flash red.
2. Choose New from the File menu.
3. On the Meter screen, choose Go Wireless Setup from the Sensors menu.
4. Select your Go Wireless Link from the list of available sensors. When paired with
the software, the LED on Go Wireless Link will flash green.
5. Collect data as desired.
4
Battery Information
Go Wireless Link contains a small lithium-ion battery in the handle. The system is
designed to consume very little power and not put heavy demands on the battery.
Although the battery is warranted for one year, the expected battery life should be
several years. Replacement batteries are available from Vernier (order code:
GW-BAT-250).
Use only the Vernier Go Wireless Charging Cable (order code: GW-CB) or
Go Wireless Charging Station (order code: GW-CRG) to charge the battery.
Storage and Maintenance of Go Wireless Link
To store Go Wireless Link for extended periods of time, put the device in sleep
mode by holding the button down for at least three seconds. The red LED will stop
flashing to show that the unit is in sleep mode. Over several months, the battery will
discharge but will not be damaged. After such storage, charge the device for a few
hours, and the unit will be ready to go.
Exposing the battery to temperatures over 35
C (95
F) will reduce its lifespan. If
possible, store Go Wireless Link in an area that is not exposed to temperature
extremes.
Water Resistance
Go Wireless Link is not water resistant and should never be immersed in water.
If water gets into the device, immediately power the unit down (press and hold the
power button for more than three seconds). Disconnect the sensor and charging
cable, and remove the battery. Allow the device to dry thoroughly before attempting
to use the device again. Do not attempt to dry using an external heat source.
Replacement Parts
Vernier Software & Technology
Part
Order
code
Go Wireless Charging Cable
GW-CB
Go Wireless Link (interface only) GW-LINK-NP
Go Wireless Battery
GW-BAT-250
Related Products
Go Wireless Charging Station (order code: GW-CRG)
Multi-unit charging capability for your Go Wireless sensors and interfaces. The
Go Wireless Charging Station is the perfect solution for charging and storing your
Go Wireless Link. For more information, see www.vernier.com/gw-crg
Go Wireless Link Teacher Pack (order code: GW-LINK-TP)
Includes eight Go Wireless Link interfaces and one Go Wireless Charging Station.
For more information, see www.vernier.com/gw-link
