83D4009
VLI31 Fireplace Insert
19
LOG PLAceMeNt
Before you begin
- This unit is supplied with seven (7)
ceramic fiber logs. Do not handle these logs with your bare
hands.
Always wear gloves to prevent skin irritation
from ceramic fibers.
After handling the logs, wash your
hands gently with soap and water to remove any traces
of fibers.
the positioning of the logs is critical to
the safe and clean operation of this heater.
Sooting and other problems may result if the
logs are not properly and firmly positioned
in the appliance. Never add additional logs
or embellishments such as pine cones or
vermiculite to the heater. Only use the logs
supplied with the unit.
Failure to position the parts in accordance
with diagrams below or to use only parts
specifically approved for this heater may
result in property damage or personal in-
jury.
PLAce ROcK WOOL (eMBeR MAte-
RIAL) IN FIReBOx
Break up rock wool (ember material) into dime-sized
pieces. Place evenly over burner, both in front and
behind the fettle. Make sure to cover all of the ports
but do not cover the slotted ports in rear. Apply rock
wool in light fluffy pieces to better enable gas to
permeate the rock wool.
Figure 16
W
ARNING
Do not use the entire
bag of rock wool to
cover burner area.
W
ARNING
LG828
rockwool area
Figure 16 -
Rock Wool Placement
LG88
LG828
VLI31 log 1 & 2
Log #1
Log #
LG88
Figure 17
LOG PLAceMeNt
1. Place Log #1 in front of the light box located in the
rear of the unit. This is held in place with an "L"
shaped bracket.
Figure 17
. Hold Log # with the flat edge to the right and the
keys on the log pointing up. Place the log on the
pins provided inside the right brick and behind the
fettle.
Figure 17
