14
Merrimack Large Insert
30004671
IMpoRTaNT NoTeS
•
Do not operate the Merrimack Large Insert if the
glass is damaged or broken.
•
Do not abuse glass by striking with any object or
by slamming the door.
•
Replace glass only with MHSC high tempera-
ture ceramic glass, available from your Vermont
Castings’ authorized dealer.
Removing and Replacing Door glass
Follow this procedure to replace glass.
•
Open the door and loosen the four retaining clip
screws that hold the glass to the door. Swing the
clips out of the way. Tilt the glass away from the door
frame and lift up. (Fig. 14) Wear gloves and use cau-
tion when handling broken glass.
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
AVERTISSEMENT
!
Un panneau vitré chaud
peut
causer des brûlures.
Laissez refroidir le panneau
vitr
é
avant d’y toucher.
Ne laisser jamais
les enfants
toucher le panneau vitr
é
.
how to Replace gaskets
Your Merrimack Large Insert uses rope-type fiberglass
gaskets to make a tight seal between some parts. With
use, particularly on those parts that move, gaskets can
become brittle and compressed and can begin to lose
their effectiveness. These will need periodic replace-
ment.
All of the gaskets used are made of fiberglass. The
three sizes of replaceable gasket are listed below, along
with their application.
Replaceable Merrimack Large Insert
Fiberglass gaskets
Gasket Size ...................And The Parts It Seals
3/8” (103564) ...............Door to the front - 5.6’
3/8” (30004) .............Firebox parts
3/16” (103556) .............Glass to the door - 5.’
To change a gasket, wait until the fire is out and the
stove has cooled. Wear protective eyewear and a dust
mask. The procedure is the same for all gaskets.
1. Remove the existing fiberglass gasket by grasping
an end and pulling firmly.
. Use a wire brush or the tip of a screwdriver to clean
the channel of any remaining cement, silicone or bits
of gasket.
3. Apply a thin bead of high temperature silicone to the
newly-cleaned groove. A 1/8” - 3/16” bead is suf-
ficient.
4. Place a new gasket into the groove. Wait until you
have placed all but a couple inches from the end
before you trim the end to an exact fit.
•
Examine the gasket that seals the glass to the door
frame. If necessary, replace this with gasket ob-
tained from your local Vermont Castings’ authorized
dealer. Directions for replacing gaskets are given
below.
•
Check the channel at the bottom of the door frame,
and clear away debris if necessary.
•
Carefully place the new glass in the door frame.
•
Secure the clips, being careful not to over-tighten.
Be sure the glass is firmly seated against the gasket.
Close the door gently to confirm the clips have been
properly positioned. It is possible for the glass to be
damaged if the clips have been installed incorrectly
and the door is closed with force.
ST1155
replace glass
Fig. 14
Replace glass.
Door
Gasket
Glass
Gasket
Glass Panel
Retainer
Clips
ST1155
